Vapour Compression system: Vapour Compression System consist of Compressor, Condenser, Receiver, Expansion valve and Evaporator. In this type of system it consist of four processes. Compression process [1-2] Condensation process [2-3] Expansion Process [3-4] Evaporation process [4-1]
First Law of Thermodynamics In this, it states that both heat and work are mutually convertible. this is also said to be that when the heat is supplied to a system should equal to network done by it. When there is both heat and work is transferred then the net energy stored in the system …
Internal Energy: The energy which is from the molecular arrangement and the motion of molecules, by this the energy is possessed in the boundaries of the system. This is also a type of stored energy. This type of energy does not depend on pressure and volume and it is a function of temperature. When the …
Thermodynamic Equilibrium: It is said to be thermodynamic Equilibrium when the microscopic properties of the system unchanged and then it is isolated from the surroundings. by the Isolated system in the course of time and which does not gets depart from it, the state of thermodynamic equilibrium is formed. On the process of this stage, …
Thermodynamic Equilibrium and the conditions required to establish it? Read More »
Explain about the Macroscopic view and microscopic view Macroscopic view: In this system the analysis is done by measuring properties like pressure, Temperature etc.. It does not explain about the mater of structure By the help of gauges, the properties are measured. In this system behave of all the molecules are equal. It takes less …
Components that required to run the vane compressor are as follows: 1) Inlet pipe. 2) Sliding vane 3) Rotor 4) Casing 5) valve 6) Roller bearings 7) Outlet pipe Inlet Pipe: This inlet pipe is used to flow the fluid into rotor inlet and this made …
Knocking Phenomenon in C.I Engine: Knocking occurs in Diesel engine due to the delay period, this occurs due to the additional amount of fuel is injected into the combustion chamber when the first amount of fuel injected into the chamber that has a delay period pass for the preparation of the flame reaction. The fuel …
Four-Stroke Cycle Engine: In this Turning movement is non-uniform, a Heavier flywheel is used. Initial stage cost is high. Volumetric efficiency is high due to Induction time is more. Small Power is produced for the same size as the engine to two-stroke. There is less in tear and wear. It requires less lubrication system It …
comparison Between Four-Stroke Cycle Engine and Two Stroke Cycle Engine Read More »
Derive energy transfer equation between fluid and rotor of the rotary compressor is as follows: Energy Transfer Equation: It can get by applying to the moment of moment theorem Torque Theoretical equation:
Methods to control the knocking in SI engine. 1.Supercharging. 2.Turbocharging. 3.Decarbonization. 1.Super Charging. Super charging is used to increase the power of the engine by supplying the required amount of fuel in to the combustion chamber to generate an required power. Advantages: By using this type of device we can decrease in space for …
Explain how to control the Knocking in S.I Engine? Read More »