Specifications of Lathe Machine. Specification of lathe depends upon the measurements of lathe machine. 1) Distance between the head stock and the tail stock is used to find the length of work done the lathe machine. and we can use required length of work piece on the machine. 2) To work on the lathe machine …
Cutting Tool Requirements: The cutting tool must have the following Requirements for long tool life. 1. Hot Hardness: The cutting tool has the ability to attain its hardness at higher temperature .the cutting tool should able to withstand high temperature. 2. TOUGHNESS: Cutting tool has the ability to resist shock, vibrations occur while cutting operation, by this …
BUILT UP EDGE: It is formed during the cutting process, continuous chip formation of metal, and cause welding up of metal chip to the cutting edge. This welded metal on the work piece is known as built up edge, by this formation the cutting tip changes to cutting edge. Points for formation of built up …
Single Point Cutting Tool geometry: Thee are various type of principle angles in single point cutting tool they are as follows: 1. Clearance angle: It is the angle between the plane perpendicular to the base of the tool and portion of the flank adjusted to its base. They are two types in Clearance angle they …
Free Body Diagrams of Mechanism and How it is Useful: A Free body diagram is a diagram of a link isolated from the mechanism in order to determine the nature of force and moments acting on links. The free body diagrams are used in: 1. To understand the physical resoning, which in turn detrmine the reactions at …
Free Body Diagrams of Mechanism and How they are Useful Read More »
Governing of turbine: It is used to run the turbine at high speed or at low speed or at constant speed can be maintain by the governing is called governor of turbine. when there is varying different loads the turbine should run with specified speed if not it causes huge damages, to get this specified …
Profile Center Line: The Profile Center Line (PCL) is an imaginary reference line used in aerodynamics and fluid dynamics to characterize the shape and geometry of an airfoil or wing profile. This line is created by joining the midpoints of the profile, starting from the leading edge (front edge) and extending to the trailing edge …
Chamber: There are three types in Chamber: 1. Upper chamber 2. Lower chamber 3. Mean chamber It is given by the curvature of the aerofoil from the leading to the travelling edge. To know about Profile center line: Click Here To know about Chord line: Click Here To know about Angle of Attack: Click Here
The angle of attack (AOA) is a fundamental aerodynamic parameter that describes the angle between the chord line of an airfoil (such as an aircraft wing or control surface) and the oncoming air or relative wind. In simpler terms, it is the angle at which the airfoil meets the oncoming air. Key points about the …
What is Chord Line? A Chord line is nothing but an imaginary line that drawn from leading edge to the edge of travelling cross sectional area of aerofoil. What is the chord line in Indian Railways? In the context of Indian Railways, the term “chord line” refers to a shorter and more direct railway line that …